Conveying stage used for creped sheet, crumb, or bale transfer between adjacent process sections.
Conveying stage used for creped sheet, crumb, or bale transfer between adjacent process sections.
Primary size-reduction equipment for cutting large rubber lumps or slab feed into smaller pieces before prebreaking.
Wet-line prebreaking equipment used after slab cutting to extrude rubber lump, reduce size, and remove internal moisture and impurity load ahead of creping.
Conveying stage used for creped sheet, crumb, or bale transfer between adjacent process sections. It is positioned inside the wet line, where front-end preparation, size reduction, moisture removal, and transfer continuity shape the rest of the process.
Used in the natural-rubber wet line for crushing, prebreaking, sheet preparation, shredding, pumping, or adjacent transfer duty.
Usually discussed together with the upstream feed condition and the next downstream wet-line interface.
Can be supplied inside complete wet-line packages or as part of focused replacement and retrofit work.
These points are usually where technical clarification becomes most important during enquiry, quotation shaping, and wider line-integration planning.
Wet-line selection should match the actual feed condition, moisture content, and the way the next stage receives material.
Stable front-end preparation helps later washing, fibre separation, dewatering, shredding, or pumping stages run more consistently.
Projects often focus on reliability, ease of maintenance, and cleaner transfer from one wet-line stage to the next.
Belt Conveyor can be positioned in complete-line delivery, machine replacement, or targeted subsystem modernisation depending on plant requirements.
New TSR10/20 lines where wet-line preparation quality influences the entire downstream process.
Existing plants replacing a front-end bottleneck or improving transfer stability before drying.
Section-by-section wet-line modernisation where a targeted machine replacement is more practical than a full rebuild.
These machines are commonly discussed alongside Belt Conveyor during line planning and technical clarification.
Primary size-reduction equipment for cutting large rubber lumps or slab feed into smaller pieces before prebreaking.
View Equipment Details
Wet-line prebreaking equipment used after slab cutting to extrude rubber lump, reduce size, and remove internal moisture and impurity load ahead of creping.
View Equipment Details
Single-screw prebreaking equipment used in the wet line to crush rubber and mechanically push out moisture before creping.
View Equipment DetailsShare the existing process stage, replacement requirement, or wider project scope and Stratvale can coordinate the right commercial and technical next step after the initial enquiry.
Use the form for clear scoping, or move directly by email or WhatsApp if you already know the equipment and project stage.
Start with a message and Stratvale can arrange a one-to-one discussion once the requirement is clear.
Discuss replacement, complete-line integration, or packaging modernisation requirements with Stratvale.
