Drying system using a thermal-oil heat source for trolley or continuous drying configuration.
Drying system using a thermal-oil heat source for trolley or continuous drying configuration.
Filling-stage equipment used to receive wet crumb, allow water drainage, and support loading into drying trolleys.
Drying system using a thermal-oil heat source for trolley or continuous drying configuration. This equipment sits inside the dryer section, where fuel route, heat-source selection, loading rhythm, and downstream packaging continuity all need to be considered together.
Used inside the dryer section to support thermal drying, dryer loading, or post-drying conditioning.
Selection is normally shaped around plant utility conditions, throughput requirement, and maintenance practicality.
Can be supplied for complete dryer-section scope or targeted replacement and modernisation work.
These points are usually where technical clarification becomes most important during enquiry, quotation shaping, and wider line-integration planning.
Dryer-section equipment must match the way crumb is loaded, retained, heated, and discharged through the wider section sequence.
Fuel route, residence time, heat transfer logic, and maintenance access are usually the key technical discussion points.
Projects are often reviewed against diesel, gas, steam, thermal-oil, coal, or biomass conditions depending on the plant.
Dryer with Thermal Oil Boiler can be positioned in complete-line delivery, machine replacement, or targeted subsystem modernisation depending on plant requirements.
New natural-rubber lines that need a coordinated dryer section rather than isolated machine supply.
Existing plants replacing a specific dryer-section bottleneck without rebuilding the full line.
Energy-route reviews where the plant needs a drying configuration better suited to local operating conditions.
These machines are commonly discussed alongside Dryer with Thermal Oil Boiler during line planning and technical clarification.
Filling-stage equipment used to receive wet crumb, allow water drainage, and support loading into drying trolleys.
View Equipment Details
Vibration-assisted filling stage used to drain free water and load dryer trolleys more evenly before thermal drying.
View Equipment Details
Trolley dryer using burner heat from diesel or gas where those utilities match site conditions.
View Equipment DetailsShare the existing process stage, replacement requirement, or wider project scope and Stratvale can coordinate the right commercial and technical next step after the initial enquiry.
Use the form for clear scoping, or move directly by email or WhatsApp if you already know the equipment and project stage.
Start with a message and Stratvale can arrange a one-to-one discussion once the requirement is clear.
Discuss replacement, complete-line integration, or packaging modernisation requirements with Stratvale.
